Description
10-8 Performance 1911 Slide Stop, Gen 2
Product Description
Our second generation slide stop is an all original design that is totally reengineered to provide you a whole new level of functionality.
Long wide pad for positive manipulation
Interior of lobe angled for easy installation – no more scratches on your slide!
Engagement surfaces optimized for positive lockback
Geometry improves slingshot slide release during reloads
Design improves detent spring pressure to minimize chance of premature lockback
.200″ pin for improved lockup
Right end of pin has protruding convex domed tip, same as GI slide stops
Fits all 1911 pattern pistols, including Govt/Commander/Officer sizes and 2011/Caspian/Para double column frames.
.45 ACP version has .200″ lobe protrusion.
9mm/.38/.40 version has .220″ lobe protrusion. **All calibers other than .45 will use 9/.38 slide stop**
Machined from bar stock and heat treated.
Carbon steel version has black oxide finish.
Stainless Steel version has matte bead blast finish.
**While this part is a drop in fit in most pistols, gunsmith fitting may be required on some guns. The .200″ diameter pin may be bigger than your factory unit (they tend to run .198-.199″) and may not drop right into the frame hole or may create a tighter lockup with the barrel’s lower lugs.
***A popular question is “will this fit in my XXX 1911.” As above, every single 1911 will be a little different, and may or may not require gunsmith fitting.
